CBM of America Informational Patch Panel
Overview
The CBM Informational Patch Panel (IPP) is a passive (non-powered) 16 port interconnection
device designed to be used in conjunction with the Datatek DT-4000. Although the DT-4000
was designed to replace the Lucent SAM16, the hardware interface from the SAM16 to the
network elements was originally DB25. Since the DT-4000 utilizes RJ45 connections to
the network elements, CBM designed the IPP to accept the original DB25 connections from
the elements while also providing visual signal indicators to aide in trouble-shooting
and installation. The IPP is 3.5 X 19 X 1.25 inches and mounts in a 19-inch rack and
can be equipped with adapters for 23 and 25-inch racks.
Features
- Six LED signal indicators for each individual port
- Switch selectable synchronous / asynchronous operation for each individual port
- Test 'loopback' port with visual indicators
Theory of Operation
The individual ports on the IPP operate in either synchronous or asynchronous
(factory default) mode depending on the position of the rocker switch on the
front of the panel. Please refer to the diagram below for the signaling characteristics
utilized in each mode ('A' for asynchronous, 'S' for synchronous). Note: The
LED Signal names are referenced to the rear of the IPP on the DB25 side. A red
LED indicates negative voltage or no signal activity, and a green LED indicates
positive voltage or signal activity. In synchronous mode the RTS LED will not
illuminate (OFF) and clock (TXC) will be present rather than CTS. Please refer
to the following page for the physical position of the LEDs and the
synchronous / asynchronous switch.
Theory of Operation (cont.)
The diagram below shows the physical layout of the front of the IPP. The remaining
ports (2-16) are not shown but have the identical layout to port 1.
Installation
Mount the IPP in the associated rack and connect to the DT-4000 with straight thru
RJ45 cables. Corresponding ports should be wired together ( i.e.: DT-4000 Port 1
wires to IPP Port 1 ). Set the Sync / Async switch for desired operation. Connect
the associated Network Elements to the Female DB25 connectors on the rear of the IPP.
Test Port Operation
The Test Port on the IPP is a loopback device with signal indicators that is used
in conjunction with the resident Datakit SAM diagnostics. To utilize this feature,
cable the DT4000 port under test to the Test Port of the IPP via the included straight
through RJ45 test jumper and execute the SAM Datakit diagnostics.
Warranty
CBM of America warrantees this product for all manufacturer and operational defects
for a period of 1 year from date of purchase. For Technical Support or information
concerning this or any other CBM product, please call 800-881-8202.
